Hitachi KP-E500 Manual do Utilizador

KP-DE500 KP-E500 Operation manual Hitachi Kokusai Electric Inc. CCD Camera Before using the camera, please read t

←・→ : The input characters can be edited by using the arrow symbols. 1) Set the flashing cursor to either of the arrow

NOTE The video level adjustment for lenses that use a video signal type lens, is adjusted using the binding screws on the side

4) Shift the cursor to “PK/AV” and push the SET button, peak / average ratio value changes. As the peak value is enlarged It reac

Auto electronic shutter (AES) This function adjusts the light amount using only the CCD shutter. Use this function with a

1) Press the SET button for longer than 2 seconds to display the “MAIN MENU”. 2) Use the UP and DOWN buttons

Setting White Balance mode 1) Press the SET button for longer than 2 seconds to display the “MAIN MENU”.

･AWC (preset white balance) After white balance condition is set, it is automatically stored in memory. Th

･PEDESTAL The optimum pedestal level has been set at the factory. If necessary, this can be changed as

･BURST [Only KP-DE500 type] Burst signal ON/OFF when a monochrome image is output is set.1) Use the UP and

External key switch connections for remote operation

General The KP-DE500 is an ultra high sensitivity color camera that utilizes the electron multiplication ty

16. White balance Selectable in 3 modes Only KP-DE500 (Factory setting is ATW) (color) Auto-tra

Phenomena inherent to CCD imaging device 1) Smear and blooming When strong light (lamp, fluorescent lamp, and reflected

Section names and functions 4 Tripod adaptor holes See camera mounting on page 11. Lens connector［LENS］ Connect lens cable when usin

Lens Connections Video output connection Connect the video output of the camera to the video input of a monit

1) Observe the maximum size limit (A in the figure) When installing the lens. Internal damage can occur

Lens connector When using an auto iris lens, install the lens plug on the lens Cable as indicated in the figures. Refer to the l

The camera setting and adjustments can be changed to conform to conditions of use. Use the setting menu indicated on the mon

1) Press the SET button for at least 2 seconds to display the main menu on the monitor screen. 2) Check the present settings at the main