Hitachi GR2000 Series Manual do Utilizador descarregar pdf (Página 188)

Hitachi Gigabit Router GR2000 Series Enhanced Version Operations - Device Management Overview

7-22 GR2K-GA-0015

Ver. 07-02

Figure 7-8 shows a sample result of the command execution when the VC connection

to the other end device is established. Figure 7-9 shows a sample result of the

command execution when the VC connection is not established.

Figure 7-8 Sample Result of ping atm Command, VC Established

Figure 7-9 Sample Result of ping atm Command, VC Not Established

Table 7-21 Additional Checkout/Action for ATM VC in Error

No. Result of ping atm Error Cause Action

1 Reachable 1. ATM encapsulation method may

be inconsistent.

2. Dynamic address resolution may

be failing.

3. Communication on IP layer or

higher may be prohibited.

1. Redefine encapsulation setting in the

configuration information.

2. Check for existence of corresponding

entry using show ip arp command. If no

entry exists, then define the address

resolution setting in the configuration

information using the arp command.

3. Perform the procedure starting from

Section 7.5.1, “Communication cannot

be done or communication is

disconnected” on page 7-23 again.

2 Not reachable 1. VPI/VCI setting may be incorrect

on the own router, on one or more

relaying nodes within ATM

network, or on the other end

device.

1. Make sure that the VPI/VCI setting on

the own router and the other end device

is correct. If the own router connects to

any carrier service, inspect the agreed

VPI/VCI range.

1 2 ... 183 184 185 186 187 188 189 190 191 192 193 ... 327 328

Sem comentários

Hitachi GR2000 Series Manual do Utilizador Página 188