Hitachi GR2000 Series Manual do Utilizador descarregar pdf (Página 66)

Hitachi Gigabit Router GR2000 Series Enhanced Version Operations - Device Management Overview

3-4 GR2K-GA-0015

Ver. 07-02

Figure 3-5 CLI Prompt Display After Login

3.2.4 Prompt

The CLI prompt at the initial introduction identifies the user levels and the command

input modes. Table 3-1 shows the CLI prompts.

In addition, in the following cases, letters represent that condition are indicated

ahead of the above prompt.

a. If the identification name of this device has been set (See "GR2000

Configuration Commands, Vol. 1-save (write) " for CLI type 1 and see

"GR2000 Configuration Commands, Vol. 1-save (write)" and "GR2000

Configuration Commands (Universal CLI) - copy running-config" for CLI type

2.), the identification name is reflected on the prompt.

b. If the operation configuration defining information is edited, and its contents

are not overwritten and saved in the configuration information file, See

"GR2000 Configuration Commands, Vol. 1" for CLI type 1 and see "GR2000

Configuration Commands (Universal CLI)" for CLI type 2. “!” is affixed on the

head of the prompt. Figure 3-6 shows the displays of (a) and (b).

c. "!!" is displayed at the beginning of a prompt when IPv4 routing protocol

information, IPv4 multicast routing protocol information, IPv6 routing

protocol information, IPv6 multicast routing protocol information, DHCP

server information, and MPLS information are edited and when the contents

of the edited information are not reflected on the operational configuration

definition information using a configuration definition command (CLI type 1)

(apply) (except the case where CLI type 2 is used).

Figure 3-6 Display Example of Prompt

Table 3-1 List of CLI prompts

User level Command Input Mode Command Execution Prompt

General user Operation command News syntax operation command >

Router

administrator (*1)

Operation command News syntax operation command #

Configuration command (*2) Configuration command (config)# (*3)

*1: To change to the router administrator to the general user, execute the

enable command.

*2: To engage the configuration definition command mode, execute the

configure command after

having become the router administrator.

*3: This prompt is displayed in the form (example: (config-if)#) in which the input mode of a configuration

definition command is added when CLI type 2 is used. (See "GR2000 Configuration Commands

(Universal CLI)" for the input mode of a CLI type 2 configuration definition command.)

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 327 328

Sem comentários

Hitachi GR2000 Series Manual do Utilizador Página 66