Hitachi GR2000 Series Manual do Utilizador descarregar pdf (Página 304)

Hitachi Gigabit Router GR2000 Series Enhanced Version Operations - Device Management Overview

8-42 GR2K-GA-0015

Ver. 07-02

(7) Network Line Loopback Test for WAN Line:

This test only sets up the own device to loopback test frames sent from the other

end device; the test frames are looped back at the own device in units of physical

layer frame. The testing applies only to T1, E1, and non-multiplexed T3,

non-multiplexed E3, multiplexed E3, multiplexed T3, OC-3c (8 ports), OC-12c (4

ports) and OC-48c lines.

For example, to test line No. 0 of NIF No. 1, enter the command lines as shown

below:

The network line loopback test can be performed by entering the test interfaces

and no test interfaces commands from the device management terminal.

(Wait about 1 minute.)

(8) Network Payload Loopback Test for WAN Line:

This test only sets up the own device to loopback test frames sent from the other

end device; the test frames are looped back at the own device in units of physical

layer frame The testing applies only to T1 (see note below) and E1 lines.

For example, to test line No. 0 of NIF No. 1, enter the command lines as shown

below: The network payload loopback test is performed by entering the test

interfaces and no test interfaces commands from the device management terminal

(Wait about 1 minute.)

(9) BERT (Bit Error Rate Test) for WAN Line:

This test loops bit-pattern test data at the other end device in units of physical

layer frame (data part only), thus useful for the fault location at a line failure and

for the checkout after the recovery of such a failure. The testing applies only to

T1, E1, non-multiplexed T3 and non-multiplexed E3 lines. The other end device

needs to have executed either the network line loopback test or the network

payload loopback test.

For example, to test line No. 2 of NIF No. 1, enter the command lines as shown

below:

The bit error rate test can be performed by entering bert and no bert commands

from the device management terminal.

(Wait about 1 minute.)

Note: Since this test only performs the setup, the test provides no display of execution result.

Testing interval, test pattern ID, or test data length cannot be defined.

Note: T1 lines in T3 synchronous multiplex lines are not supported.

Note: Since this test only performs the setup, the test provides no display of execution result.

Testing interval, test pattern ID, or test data length cannot be defined.

1 2 ... 299 300 301 302 303 304 305 306 307 308 309 ... 327 328

Sem comentários

Hitachi GR2000 Series Manual do Utilizador Página 304